Huzzah, I’m finally at the early build stages! As you can see by the picture to the right, the top and bottom frames of the bar have been put together and mounted on the front panels (in this picture, the bar is laying on its eventual front). Does it look like a bar yet? Not likely. I have a few concerns at this stage already. On the left, you see the wide bottom frame. A piece of 1/4 oak plywood goes on top of that frame to form the base of the liquor cabinet portion. I’m worried that the weight of bottles will be too much for the 1/4 wood. I think I’ll upgrade the base with an extra 2×4 stud piece that I’ve got left over. I should have attached it before the frame was attached, but such is life. My second concern is the side frame. There are no 2×4’s for support on the frame. Instead, the bar will rely on the 3/4″ oak plywood sides (not seen here yet) to bear the weight. I would have thought that building a full 2×4 frame would be more solid. I’m not going to bother changing anything on that though, since I’m sure the designer has had plenty of successful builds to his credit.